How To Fix an Atomiser Short or No Atomiser Message!
Atomisers and pods are essential components of vape devices that convert e-liquids into tasty vapours, but sometimes, vapers encounter messages on the device like “atomiser short” or “no atomiser” which can be frustrating. In this blog post, we'll explore the common causes of atomiser short or no atomiser messages and some simple ways to fix them.
What does Atomiser Short or No Atomiser message mean?
Atomiser short or no atomiser is a message that indication that your vape device is not detecting the atomiser or pod, or the coil's resistance is below the recommended level, resulting in a short circuit. When this happens, the device won't fire, and you'll be left scratching your head wondering what went wrong.Common Causes of Atomiser Short or No Atomiser messages
Dirty or damaged connection points: The connection points between the atomiser or pod and your device can become dirty, gunky or covered with e-juice residue, leading to a poor connection. This can result in your device not detecting the atomiser.
Damaged or faulty coil: Your coil can become damaged over time, especially if you don't replace it often enough. A damaged coil can cause an atomiser short or prevent the device from detecting the atomiser. Sometimes, though not often, a brand new coil may faulty right out of the box.
Incorrect coil installation: If you install your coil incorrectly, it can cause an atomiser fault message or prevent the device from detecting the atomiser or pod.
Low battery: A low battery can cause an atomiser fault message and prevent the device from detecting the atomiser or pod. This happens because your device might not have enough power to heat the coil properly.
Damaged device: A damaged device can also cause an atomiser fault message or prevent the device from detecting the atomiser. This can occur due to wear and tear or accidental damage. This is the least common likely cause, but could be the case if all other trouble shooting fails.
How to Fix Atomiser Short or No Atomiser message.
Clean the connection points: Use a clean tissue or cotton swab to remove any dirt, grime, or e-juice residue on the connection points between the atomiser or pod and your device. This should restore a good connection.Replace the coil or pod: If your coil is old, replace it. If you are using a pod with a coil that can’t be changed then try a new pod.
Test your atomiser on another device: If you have a spare mod handy, test out your tank on that device. If it works on another device this could indicate an issue with the mod.
Reinstall the coil: Check your coil installation to ensure you installed it correctly. If not, reinstall it correctly.
Charge your battery: If your battery is low, charge it fully. This will provide enough power to heat the coil properly.
Comments
0 Comments